Is your Google WIFI blinking orange? Can’t you stream your favorite shows and movies using Linksys extender? Well, need not to worry! Let’s help you fix the issue in a fly. This troubleshooting guide will help you make your Linksys extender up and running so that you can enjoy seamless internet connectivity throughout our house. Let’s get started!
Your Linksys WiFi range extender consists of LEDs on the front panel or depending upon the model you are using that gives you information about your device activity:
Blinking Green: The blinking green LED on your Linksys extender indicates the following:
- Your device is starting up.
- It is resetting to factory default values and you have to initiate the extender setup process again.
- The firmware version on your Linksys device is updating.
Solid Green: This color LED indicates that your Linksys WiFi range extender is ready to use.
Solid Orange: The solid or amber color LED indicates that the Ethernet or wireless connection between your extender and router is poor. In that case, you have to unplug your devices, wait for a couple of minutes, and then plug them back in again.
Google WIFI Blinking Orange: It means that your Linksys extender and router and still not connected. In such a case, make sure that you have an internet connection and the power being supplied to your devices is continuous.
What if your Linksys extender keeps blinking orange? Don’t sweat over it! To get rid of the problem, go through the steps outlined underneath.
Troubleshoot Blinking Orange LED Issue
Blinking orange LED issue can occur either after performing Linksys extender reset or updating its firmware. No matter why you are getting this annoying issue, the tips provided below will help you fix it in no time. Keep scrolling down.
Reboot Your Linksys Extender
You may find the rebooting process quite simple but it works in most cases. Simply unplug your Linksys extender from its wall outlet and plug it back in again after a few minutes. After giving your device a fresh start, see whether the Google WIFI blinking orange LED issue has been fixed or not.
Check the Firmware Version on Your Extender
On the off chance if you are getting the blinking orange LED issue right after updating the firmware on your Linksys extender, then check if you have downloaded and installed the correct firmware version. Bear in mind that updating wrong firmware version can also lead you to blinking orange LED issue. So, you are suggested to update the correct firmware version for your device by navigating to Linksys extender login page and following the on-screen instructions.
Check the Cable Connections
Your Linksys device might be blinking orange if there is an issue with the wired/ Ethernet connection. So, check if your Linksys extender and router are properly connected using an Ethernet source. Apart from that, cross-check the power outlet in which your Linksys extender is plugged in. It shouldn’t be damaged or fluctuated. And, the power being supplied to the device must be steady.
Note: If you are still getting blinking orange LED on your Linksys extender even after connecting it to your router properly using an Ethernet cable, then try connecting them using a wireless source.
In the event that you are getting the face issue after connecting your devices wirelessly, perhaps it seems like your existing router is not compatible with your Linksys extender. And if you want a compatible device, Linksys router is the best choice. Just add it to your Linksys extender and see the difference. And if you want to take your WiFi experience to the next level, don’t forget to perform Linksys router setup.
Reset and Reconfigure Your Extender
Yes, you read it absolutely right! Partial or improper Linksys extender setup can let you experience the annoying issue. In that case, it is advised to reset and then reconfigure your extender using the on-screen instructions provided on Linksys WiFi setup page.
